top of page

Australian sunglasses and fashion spectacle standard

ISO 6789-1:2017

​

Assembly tools for screws and nuts - Hand torque tools - Part 1: Requirements and methods for design conformance testing and quality conformance testing: minimum requirements for declaration of conformance

ISO 6789-1:2017 specifies the conformance testing and marking requirements for hand torque tools used for controlled tightening of screws and nuts. It also specifies the minimum requirements for declaration of conformance for hand torque tools. ISO 6789-1:2017 applies to hand torque tools which are classified as indicating torque tools (Type I) and setting torque tools (Type II). NOTE Hand torque tools covered by this document are those identified in ISO 1703:2005 by reference numbers 6 1 00 11 0, 6 1 00 11 1 and 6 1 00 12 0, 6 1 00 12 1 and 6 1 00 14 0, 6 1 00 15 0. ISO 1703 is currently under revision. In the next edition, torque tools will be moved to an own clause, and with this change the reference numbers will also change and additional reference numbers will be added. ISO 6789-1:2017 does not specify requirements of calibration certificates for hand torque tools. These are described in ISO 6789‑2.

​

ISO 6789-1:2017

​

​

For questions relating to standards, please fill out the form below, to obtain/purchase a copy of relevant standards, please go to the Standards Australia store

Get in Touch
Australian technical standards: Programs

Bicycle Industries Australia

0438-871-271

  • facebook

©2020 by Bicycle Industries Australia

bottom of page